Transmission fluid change-which method is better? - READ ONLY

99 messages, Last post on Jul 10, 2002 at 6:37 AM

You are in the Maintenance & Repair - Archived Discussions Forum. Your Host is mr_shiftright

This discussion is ARCHIVED. To reactivate the discussion, post a request in the Lost? Ask the M&R Host for directions! discussion.

What is this discussion about? Transmission

Outline

Messages Page 2 of 11: 1; 2; 3; 4; 5; 6; 7; ...; 11; Prev; Next; Last

#3 of 99 You can also get a drain plug kit for the pan by zr2rando Feb 24, 2002 (4:36 pm)
You can get a kit to install a drain plug for the pan so you can empty it before dropping it to change the filter,,,but you have to drop the full pan the first time to install it..oh well, so much for the easy first time huh!! While under warranty I would do what the book says to do. After the warranty I would do the 100% fluid flush about every 30k and change the filter after every other flush. Keeping newer fluid in the transmission helps keep seals in good shape and keeps the fluid properties at new fluid levels and avoids any heat related decomposition from being a long term issue. The transmission filters I have seen did not have any blockage issues, the main issue was the fluid condition
#4 of 99 by alcan Feb 24, 2002 (5:16 pm)
Remove the pan. Replace the filter and reinstall the pan. Add about 4 quarts of fluid. Remove the cooler return line (from upper fitting at rad) at trans and attach a length of hose to direct fluid into a catch pan. Have an assistant start the engine and pour fluid into the trans at the same rate it's being pumped out. When the discharge is clean fluid, shut the engine off, reinstall the cooler line and top of the trans in the usual manner.
#5 of 99 by kmag Feb 24, 2002 (7:23 pm)
Maybe Ive just been lucky. My 94 escort GT has 115K miles with 1 transmission service at 75K. I had it pumped at the local oil change place. Tranny shifts just as rough as when I bought it at 20K miles CLick & Clack, the guys on NPR, said that if you have 75-100K, dont open it up, its just as likely to cause problems.
#6 of 99 Drain and Fill by armtdm Feb 25, 2002 (5:29 am)
Many newer cars have a drain plug for tranny fluid. I have a toyota, Merc, Isuzu that have plugs my GM product does not. So a drain and fill is very easy. On my 92 Toyota I did the first drain and filter change (dropped the pan) at 25,000 miles. I have only drained and filled via the plug every 30,000 since then (have not changed the filter since 25,000) and now have 142,000 on tranny. Granted you only get about half the fluid each time but that is fine. I use synthetic ATF A "flush" (not a pump out change ) is fine but "no one does it properly" due to cost. After flushing the system the pan should be dropped as the gunk is removed and sits in the pan and can and has caused problems. Now, if you are simply pumping out the old fluid via the cooler line then that is fine. However, overall I think this is overkill. For the cost of fluid (if you have a plug) drain and fill yourself. Measure the amount taken out as this is much easier then filling up and overfilling as it is a pain to remove the fluid if overfilled. Remember, check when tranny is hot and engine running.
#7 of 99 by alcan Feb 25, 2002 (6:19 am)
"A "flush" (not a pump out change ) is fine but "no one does it properly" due to cost." No one does it properly? Not one? Nobody at all? Anywhere? Ever? Btw, some newer models of flushing machines attach to the trans at the pump suction port normally occupied by the filter. They make a bit of a mess but they replace all of the fluid. Every drop. How one could attach one of these flushers to the trans without first removing the pan and filter is beyond me.
#8 of 99 Never by armtdm Feb 25, 2002 (6:52 am)
The reason no one does it properly is cost. After flushing the tranny with their solvent they refuse to drop the pan saying it is not necessary due to cost (and they claim the flush got everything out) . It would add more time/labor plus new filter gasket etc. and they already overcharge for the service and the customer does not wan tot pay more as well.
#9 of 99 by alcan Feb 25, 2002 (7:03 am)
Who's this "they" you refer to?
#10 of 99 by 8u6hfd Feb 25, 2002 (7:13 am)
$90 for a drop the pan, change the filter, etc. for our 93 Caravan at a Arlington, VA shop sounds good to me. A drain and refill at the dealership costs almost as much. For the Caravan, it's cheaper than a new transmission.
#11 of 99 Ford Transmissions by rayfbaird Feb 25, 2002 (8:58 am)
Since in the past they have been a weak component, I drain the fluid, replace the transmission seal and filter every 15K. Since you've gone 30K I would recommend a complete flush in addition to the procedure described above. If I have full synthetic then I go 30,000.
#12 of 99 8u6hfd by alcan Feb 25, 2002 (9:06 am)
$90 is reasonable considering that Chrysler vehicles up to 1999 require the usually more expensive ATF+ (Type 7176) fluid. Btw, you should verify the fluid used, as DexronIII/Mercon may cause torque converter clutch shudder and/or deteriorated shift quality.

Messages Page 2 of 11: 1; 2; 3; 4; 5; 6; 7; ...; 11; Prev; Next; Last

New? Join Now!

Forum Tools

Search Forums

Browse by Vehicle

Browse by Board

Browse by Topic

View All Topics

Today's Chats

Chat Schedule