You are here: Forums Maintenance & Repair Maintenance & Repair - Archived Discussions Transmission fluid change-which method is better? 

Transmission fluid change-which method is better? - READ ONLY

99 messages,  Last post on Jul 10, 2002 at 6:37 AM

You are in the Maintenance & Repair - Archived Discussions Forum. Your Host is mr_shiftright

This discussion is ARCHIVED. To reactivate the discussion, post a request in the Lost? Ask the M&R Host for directions! discussion.

What is this discussion about? Transmission

Messages Page 11 of 11 1 ... 5 6 7 8 9 10 11 Prev Next Last

Go To Msg # Search This Discussion

#98 of 99 by alcan Jul 10, 2002 (3:42 am)
The line to disconnect is the return (upper) line from the cooler at the trans. This cleans out the cooler as well.   Regarding elaborate schemes re brazed fittings on buckets, etc, to refill the trans, forget it. Pump suction is from the lower sump in the trans, which coincidentally is where the filter is usually located, not from a cooler line.
#99 of 99 by wain Jul 10, 2002 (6:37 am)
I like the just drain it method. lots of chances to disturb dirt or do something wrong with the filter change method.

Messages Page 11 of 11 1 ... 5 6 7 8 9 10 11 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Maintenance & Repair Maintenance & Repair - Archived Discussions Transmission fluid change-which method is better?